How to Connect POE NVR via the Onvif Protocol?

HomeGuideHow To

How to Connect POE NVR via the Onvif Protocol?

How to Connect Non-POE or Wireless IP Camera to POE NVR via the Onvif Protocol? Usually, the POE NVR system we sell includes several POE IP cameras

How to Setup Your Uniview Security System
How To Set Up Audio On Uniview
How do I install D-Link series camera?

or Wireless IP to via the Protocol?

Usually, the POE we sell includes several POE so that can be plugged into NVR's port directly.

Load More : Tutorial of General IP Security System

But some customers may need to connect non-POE IP to NVR.

In this situation, the cameras should meet two requirements below.

1. The must support the onvif protocol.

2. The IP camera's had better equal to or lower than resolution NVR.

3. The camera should be connected to the router, by cable, or by wifi. Therefore, a wireless camera is also OK.

Here are the steps:

1. Please use a cable to connect the IP camera to a router, and connect the camera to a power source by adapter.

2. Connect the NVR to the same router by network cable.

3. Go to the Main Menu—Config—Channel to search the camera's IP.

mceclip1.png

4. It will detect the camera's IP. Add it to the system.

Come back to the main screen and the image of the IP camera appears.

COMMENTS

WORDPRESS: 3
DMCA.com Protection Status