How to set IP address for IP cameras - NVR IPCAMERA SECURITY
Guide How To

How to set IP address for IP cameras

set IP address for configuring

Description

If a network video is on one IP gateway without a router (or just on a switch) and your cameras are on another gateway then there can be a problem with changing the IP of the cameras. This article will explain how to your computer as the host connection for an IP or IP device. From here you can the of the camera to match that of your network recorder.

Prerequisites

  • Connect a ethernet cable from camera to NVR Then connect a cable from NVR to PC.
  • Set PC and Camera on same Network.

Set the IP address of the PC/ laptop same as the camera.

Video Instructions

Instructions

Step 1. Right Click on the Windows Start up âžž Click on Control Panel.

Set ip locally wiki 1.png

Step 2. Click on Network and Internet âžž Select Network Sharing Center âžž Select on Change Adapter Settings âžž Select Ethernet

Set ip locally wiki 2.png

Set ip locally wiki 3.png

Set ip locally wiki 4.png

Set ip locally wiki 5.png

Step 3. Select the Network Tab âžž Check off Internet Protocol Version 4 (TCP/IPv4) âžž Click on Internet Protocol Version 4 to highlight âžž Click on Properties

Set ip locally wiki 6.png.

Step 4. Set IP Address in the same range as the IP Camera Address. Ensure the Subnet Mask and Gateway of the PC are the same from the camera. Click OK .

Set ip locally wiki 7.png

About the author

M.Salih ASLAN

Hello, I live in Salih Turkey. I serve in dvr, nvr, security and surveillance industry. Write to me for any comments and suggestions ..

2 Comments

Click here to post a comment