Lorex – How to reset the password DVR NVR All Model

HomeGuideHow To

Lorex – How to reset the password DVR NVR All Model

At Lorex, we take your security seriously. As such, we do not give our customers the option to reset the recorder on their own. If you forget the pass

Advanced Uniview IP Camera Guide
How to reset IPC.NVR.DVR password Cloudsee NVSIP ADVR
Hikvision Hik-Connect complete setup guide

At , we take your seriously. As such, we do not give our customers the option to the on their own. If you forget the of your recorder, you will have to call our and request for a , so you can reset your .

This article applies to all older models of  and the following new N841N842N843N861.


Part 1 – Call our

Step 1. Locate and retrieve your recorder's Device ID. In most cases, the Device ID is printed on a label on the top or side panel of the recorder along with the  (see image belowNOTE: The Device ID is NOT the Serial Number.

QR Code

TIP: There are three ways of retrieving your recorder's Device ID or QR Code:

  1. As mentioned above, you can locate the Device ID on a label on the top or side panel of the recorder.
  2. You can also see Device ID by going to your recorder's app (i.e., go to Settings > Device Info).
  3. Finally, using a monitor and a mouse, you can retrieve the Device ID by accessing the Info Page of your recorder (i.e., right-click on mouse, then click Info (see image below).

Device Info

Step 2. Once you have the Device ID at hand, call our Technical Support at 1-888-425-6739 and ask for a temporary password so you can access your recorder and reset the password.

Call Tech Support

Call Tech Support


Part 2 – Log in to your recorder using the temporary password

NOTE: For this procedure, you must (1) monitor to your recorder using an , and (2) connect a mouse to one of the USB ports of your recorder.

Step 1. Right-click on the mouse, then click Main Menu.

Right-click

Step 2. Now, log in to your recorder to open the Main Menu (see image below). You will need to provide the following credentials:

  • Username:  ()
  • Password: Use the temporary password provided to you by the Technical Support

Click OK to proceed.

Log in

Step 3. On the Main Menu, click Settings (see arrow on the image below) > System > Account > User.

Main Menu

Step 4. In the User Settings, click Modify.

Modify

Step 5. Then,  the following settings:

  • User:  (default)
  • Modify Password: Check the box
  • Old Password: Enter the temporary password provided to you by the Technical Support
  • : Enter your new password
  • Confirm Password: Re-enter your new password

At the bottom of the screen, click OK to save your changes.

Configure

NOTE: Now, make sure to keep your new password in a safe place for future use.

Congratulations! You have successfully reset your password.

 

COMMENTS

WORDPRESS: 84
DMCA.com Protection Status