Invalid encryption key” Error Message

HomeGuideNVR

Invalid encryption key” Error Message

Error message: "The stream is encrypted. Please go to the Local Configuration interface to set the Encryption Key and restart live view." Seen a

LTS Patinum NVR-DVR How To Password Reset
UNIARCH NVR DVR Full installation user manual
Basic Setup & Adding Cameras Amcrest

Error message:

“The stream is encrypted. Please go to the Local interface to set the Encryption Key and restart .”

Seen as a pop-up in the bottom right hand corner of your screen, when trying to access the streams from  cameras on Live View.

Navigate to Configuration –> Advanced –> and set the encryption key ().

The ‘key' that you need to enter is actually the “Verification Code” that you set when you enabled and set up the Platform Access for Hik-.

i.e. the Verification code that you entered here:

You need to enter this verification code / encryption key via the web browser of any PC (even on the same LAN) that you wish to access the from.

You will need to enter the code / key here:

You then need to disable encrypted streaming on the itself.

This can only be done (enabled/disabled) via a monitor directly connected to your NVR.

You will need to navigate to Configuration –> –> Access Platform and un-tick “Enable Stream Encryption”.

You should now be able to see the “live view” in your web browser.

COMMENTS

WORDPRESS: 45
DMCA.com Protection Status