How to Upgrade Emergency alarm station by RS232 Cable

HomeGuideHow To

How to Upgrade Emergency alarm station by RS232 Cable

When Panic Alarm Station can’t be searched in SADP, can’t ping IP successfully or the device is crashed. In this situation, security control panel nee

Troubleshooting your Ring-connected ONVIF-compatible camera
Wyze Cam v3 Setup Guide NEW
How to Setup Your Uniview Security System

When Panic Station can't be searched in SADP, can't ping IP successfully or the is crashed. In this situation, control panel need to be upgraded by RS232 cable.
Important Note: Computer must close the firewall.

1. laptop USB port with Panic Station by RS232 cable.

2. Check the COM port in computer's device .

3. Open SecureCRT and below parameters.

4. Hold down the Enter key when the Panic Alarm station power on.

5. Enter b.

6. Then enter pri , check device start IP environment.

7. Change device IP environment during time.(address set depend on your network environment)
setenv serverip 10.9.98.35;
setenv ipaddr 10.9.98.20;
setenv gatewayip 10.9.98.254
— serverip :PC
— ipaddr :Device
— gatewayip :Gateway address

8. Enter pri again, check these IP address have been changed.

9. Enter ping 10.9.98.35 , check device and PC is connected.
Host 10.9.98.35 is alive means connection is ok.

10. Copy to the tftp catalog, then open tftp.

11. Enter .

12. successful.

COMMENTS

WORDPRESS: 5
DMCA.com Protection Status