Preparation

• 1. The model of optical fingerprint recorder is DS-K1F820-F;
• 2. Please download the iVMS-4200 Client on Hikvision official website;

http://www.hikvision.com/en/Tools 84.html

And in this document, we use V2.7.0.6 iVMS-4200 Client;

Step 1:

Connect the optical fingerprint recorder to computer directly via USB port, it will install driver

automatically

Step 2:

Run iVMS-4200 Client, enter Access Control interface;

Add Organization and Person first;

Step 3:

On Add Person interface, enter Fingerprint interface, select Local Collection Collection Mode, and click Set Fingerprint Machine;

Step 4:

On Fingerprint Machine interface, please select correct device type and click Save;

Step 5:

Add fingerprints, select your finger and click Start;

And put your finger on scanner;

HIKVISION

Note:

The touch area between finger and sensor decides the information content of the collected fingerprint. The more information the device sensed, the higher of the pass rate. Thumb, forefinger, middle finger are suggested to use in order to improve fingerprint identification rate.

Correct Scanning: the figure displayed below is the correct way to scan your finger:

You should press your finger on the scanner horizontally. The center of your scanned finger should align with the scanner center

Step 6:

Adding fingerprints succeeded, you can also obtain fingerprint quality as following picture;

Click Stop to finish adding fingerprints;

And click OK to save person information;

Step 8:

Click OK to save your configuration;

The person information as following picture shows;

Step 9:

You can also click Modify to enter Edit Person interface, and back to Step 3;